Tool // Reconstitution
Peptide reconstitution calculator
Enter the mass stated on the vial and the volume of solvent you add. The calculator returns the concentration obtained, the mass contained in a drawn volume, and the equivalent in U-100 insulin units. It is arithmetic — it proposes no volume to draw, no frequency and no route of administration.
What this calculation does not tell you
- It recommends no volume to draw, no frequency and no route of administration.
- It does not replace the safety data sheet or the laboratory's own protocol.
- Stability after reconstitution is given in the specifications table on each product page; it depends on storage conditions.
- Catalogue products are reference materials for in-vitro research only. They are intended neither for humans nor for animals.
The formula
The concentration obtained is the mass stated on the vial divided by the volume of solvent added. There is no second step and no correction factor: 10 mg in 2 ml gives 5 mg/ml. The mass of peptide does not change with the volume — adding solvent dilutes a constant mass, it does not create more of it.
The difficulty is never the division, it is the units. Vials are labelled in milligrams, U-100 insulin syringes are graduated in units (1 ml = 100 units), and the literature often works in micrograms. Three scales for one calculation, and that is where a factor of 1,000 or a factor of 100 slips in. The table above gives the U-100 equivalent for each volume so the conversion is not left to be done in your head.
Choosing the volume rather than inheriting it
The volume is not imposed by the product: you set it, and it determines how finely later withdrawals can be measured. A small volume gives a concentrated solution — less solvent to store, but the relative error on a small withdrawal becomes significant. A larger volume gives a more dilute solution and wider, therefore more precise, withdrawals. The only constraint is physical: a 2 ml vial cannot take 5 ml.
The solvent determines how long the vial remains usable. Bacteriostatic water contains about 0.9 % benzyl alcohol, which permits repeated withdrawals; sterile water contains none and suits a single use. The analytical glossary defines the terms used here, and the FAQ covers storage after reconstitution.
Check the vial before reconstituting it
This calculation starts from the mass printed on the label and assumes the vial contains it. Quantitative content — the mass of peptide actually present, as opposed to the mass weighed out — is part of the lot report, because counter-ions and residual water make the two differ. Where a report is published for the dosage you hold, the measured content is the figure to divide by.
Catalogue → · Frequently asked questions → · Calculateur en français →